How to retrieve measurements with the SDS1000X-E series of Oscilloscope

The command sequence for returning measurements with a SIGLENT SDS X and XE series of oscilloscopes is as follows:

MEAD <type>, <source> Activate measurement type

Where <type> = {PHA, FRR, FRF, FFR, FFF, LRR, LRF, LFR, LFF}

The PHA is phase, the others are the same as the specified type of the instruments delay measure in the SDS programming guide.

<source> = {C1-C2, C1-C3, C1-C4, C2-C3, C2-C4, C3-C4}

<source>:MEAD? <type> Return measurement data

Where <source> = {C1-C2, C1-C3, C1-C4, C2-C3, C2-C4, C3-C4}

<type> = {PHA, FRR, FRF, FFR, FFF, LRR, LRF, LFR, LFF}

The PHA is phase, the others are the same as the specified type of the instruments delay measure in the SDS programming guide.

The following example shows the command sequence to enable phase measurements between CH1 and CH2 on an SDS1202X Oscilloscope.

NOTE: The SDS1202X was set to default factory settings, CH2 was activated manually, and 2 sine waves with different phases were used as inputs to either channel.

The commands were sent using NI-MAX VISA Test Panel.

Here is the default display. Note, there are no measurements active on the display.